UPS Trainer (VPL-UPST)

This UPS Trainer provides complete set up for the practical and experimental knowledge of a general circuit of On-Line U.P.S. with fault creating facility. This is very helpful in understanding the working of UPS

  1. General Details

    UPS Trainer (VPL-UPST)

    Features:

    • Circuit diagram printed on PCB
    • Transformer based power supply
    • Strongly support by systematic operating instructions
    • Enclosed in an attractive ABS plastic/wooden box

    Note: Specifications of any product can be changed or added without notice in our constant efforts for improvement.

  2. Specifications
    Input Voltage 180-260 Volts, 50 Hz
    180-260 Volts, 50 Hz 230 Volts ± 1%
    Inverter efficiency 80% minimum
    Over Load Capacity 110% for 15 minutes
    Cooling Forced air cooling
    Technology PWM
    Rectifier Type Constant Voltage & current, controlled with facility to change the battery in float, Boost & Trickle modes with automatic change over between float & Trickle mode.
    Ripple in D.C. Less than 2%
    Protection Over Load, Low Voltage, High Voltage & Battery Over Charge, Deep Discharge, Short Circuit.
    Indication Output, Charger & Battery Operation.
    Isolation The Output is isolated from the line, Provided with spike, Surge, Noise, RFI, & EMI suppression.
    Fault Creation Provided on board
    Test Points Provided on board to observe the waveform and signals
    Cabinet Enclosed in an attractive ABS plastic / wooden box
    Standard Accessories Instruction & Experiment Manual

    Note: Specifications of any product can be changed or added without notice in our constant efforts for improvement.