Electronic & Communication Trainers
FM Transmitter & Receiver Trainer (VPL-CT-FMTR)
SALIENT FEATURES
- On board Audio Oscillator FM Modulator, Demodulator, Low Pass Filter, Amplitude Limiter & Filter Sections.
- Onboard Test Points & Fault Switches.
- On board audio jacks provided for Microphone and Earphone connection.
- Onboard speaker provided for Audio.
- Onboard Transmitting antenna.
Fourier Synthesis System Trainer (VPL-CT-FST)
SALIENT FEATURES
FPGA Trainer Kit (VPL-SPARTAN-50L/100L)
We are a notable company for offering FPGA Trainer Kit to our most valued clients. The offered product is strictly checked on every stage while preparing in order to ensure the finest functionality. It is widely demanded in the market for perfect quality.
Frequency Division Multiplexer/ Demultiplexer Trainer (VPL-CT-FDM)
SALIENT FEATURES
- On board Balanced Modulator, Audio Oscillator, Audio Input, AC Amplifier Low Pass Filter, Carrier Generator.
- Onboard Test Points & Fault Switches.
- On board audio jacks provided for Microphone and Earphone connection.
Frequency Modulation & Demodulation Trainer (VPL-CT-FM)
This is also the basic Trainer in Communication Lab Series. Frequency Modulation & Demodulation Trainer VPL-CT-FM is widely demanded for perfect performance. This range is prepared in line with the set industry standards.
Frequency Modulation Trainer Kit(CT-FMT)
Pioneers in the industry, we are engaged in offering a wide and high-quality assortment of Frequency Modulation Trainer Kit to the clients. The entire range is tested over the grounds of quality parameters to ensure the delivery of flawless products to the clients’ premises.
Frequency Shift Keying Modulation & Demodulation Trainer (VPL-CT-FSK)
Frequency Shift Keying Modulation & Demodulation Trainer VPL-CT-ASK is widely demanded for perfect performance. This range is prepared in line with the set industry standards.
Fuzzy Logic Control Trainer (VPL-FLCT)
DESCRIPTION
The open design of the Fuzzy Logic Control Trainer (VPL-FLCT) allows the range of fuzzy logic and control experiments to be developed and extended as required to suit the specific interests of the user. In the case of fuzzy control, any external system with compatible inputs and outputs may be considered for control using fuzzy logic via the VPL-FLCT.
GROVE – GAS SENSOR (MQ9)
Description
It can detect combustible Carbon Monoxide, Coal Gas and Liquefied Gas. The sensitivity can be adjusted by the potentiometer. This is an Analog output sensor. It needs to be connected to any one Analog socket in Grove Base Shield. It is possible to connect the Grove module to Arduino directly by using jumper wires. When doing so, please refer to the connection table below:
GROVE – HCHO SENSOR
Description
Its design is based on the WSP2110 whose conductivity changes with the concentration of VOC gas in air. Through the circuit, the conductivity can be converted to output signal that corresponding to the gas concentration. This sensor can detect the gas whose concentration is up to 1 ppm. It’s suitable for detecting formaldehyde, benzene, toluene and other volatile components. This product can be used to detect harmful gas in the home environment.
GROVE – TILT SWITCH
Description
The Grove-Tilt Switch is the equivalent of a button, and is used as a digital input.
Inside the tilt switch is a pair of balls that make contact with the pins when the case is upright. Tilt the case over and the balls don’t touch, thus not making a connection. It is wired to the SIG line, NC is not used on this Grove module.